DRL Help!

[snoosebomb]

ok , DRL off and no lo beam , hi beam work .
 95 CDN 8V .  
At the DRL module R/W  wire fried inside module [ still has 12v ] . no blown fuses

module wiring left side top down R/GRN , R/ W , R/BLU ,,,,, PPL/Y , W/ R ;;;   other side BLK/W , BLK , OR/W , PPL/GRN, BRN/Y

Is there a way to rewire around to get lo beam ? don't care about DRL

and/ or run a new wire and switch from batt or fuse box?

thanks for help,

sure the only pain is burned pins on the DRL module that all just love to do.

is this 11 pin DRL?
my DRL page has this PDF link I made up

https://fixkick.com/power-elect/DRL/95-97DLR-USA.pdf



normally all you do is cut or remove the DRL large resistor in the right finder top (hidden) and DLR GOES DEAD.

but if pin 2 is burned up lows are dead. totally. ahhh that  is your red/white burned wire, oops.  the PDF is clear.
as you can see the head lamps all 4 filaments have power all the time even keys in pocket.
so cut pin 1 and 2 wire and short them to each other.  just this does it.  now the Lows work on demand by you. burned up jack.  (head lights switched  on)

let me know if has problems, makes sure both fuses good. F11/F12


Thank you so much , just to be clear , join R/GRN to R/ W ?  or 1 to 2 ,,


It WORKED !