Front Hub Seal Orientation

[Huppbrian]

Okay. I'm officially an idiot. I wanted to replace the front hub seals and bearings on my 4WD 1996 Tracker. I ordered the parts, and while I was waiting I took everything apart but forgot to note the orientation of the seals. It's not obvious. Which way is in and which way is out?

[fixkick]

no problem.
there are the seals for the backing plate tub those are NOT obvious. I call the brake tub seal.
and then the real main rear seal on axle stub.?
spindle back. (main wheel hub rear center)
that has a lip and the side with the spring goes inside.

nice graphic here
http://evolution.skf.com/wp-content/uplo...pays01.png

[Huppbrian]

no problem.
there are the seals for the backing plate tub those are NOT obvious. I call the brake tub seal.
and then the real main rear seal on axle stub.?
spindle back. (main wheel hub rear center)
that has a lip and the side with the spring goes inside.

nice graphic here
http://evolution.skf.com/wp-content/uplo...pays01.png

Thanks. This site is da bomb!