Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Front Hub Seal Orientation
#1
Okay. I'm officially an idiot. I wanted to replace the front hub seals and bearings on my 4WD 1996 Tracker. I ordered the parts, and while I was waiting I took everything apart but forgot to note the orientation of the seals. It's not obvious. Which way is in and which way is out?
Reply
#2
no problem.
there are the seals for the backing plate tub those are NOT obvious. I call the brake tub seal.
and then the real main rear seal on axle stub.?
spindle back. (main wheel hub rear center)
that has a lip and the side with the spring goes inside.

nice graphic here
http://evolution.skf.com/wp-content/uplo...pays01.png
http://www.fixkick.com
Reply
#3
(09-30-2015, 01:15 PM)fixkick Wrote: no problem.
there are the seals for the backing plate tub those are NOT obvious. I call the brake tub seal.
and then the real main rear seal on axle stub.?
spindle back. (main wheel hub rear center)
that has a lip and the side with the spring goes inside.

nice graphic here
http://evolution.skf.com/wp-content/uplo...pays01.png

Thanks. This site is da bomb!
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)