Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Can't find the PCV valve
#1
I'm looking for the PCV valve so I can replace it (I assume PO did not do 50k replacement). There are several distinct PCV valves for sale on rockauto, and I think I know which one I need, but I wanted to pull the old valve first to see. The problem is that I can't find the PCV at all. I looked at the FSM and pulled the cam vent tube (leaking oil incidentally), realized my mistake, but could not find the correct one.
Reply
#2
the 8v the PCV screws in the intake man..so has this large pipe thread, NPT.
the 16v engine, is 100% hose fittings. and the one end going in to the top center plenum in a grommet.

here is 16v (my coin toss)

see that nylon deal bob there. bingo.
http://www.fixkick.com/engine/97-motor-p...eviewl.jpg

8v is in my intake, slide
http://www.fixkick.com/engine/8v/vacuum%...age_2.html

both early and late. in one photo.
http://www.fixkick.com
Reply
#3
Thanks, I found it. In retrospect, I could have followed the huge trail of oil to the valve...

Also, watch out on rockauto.com, most aren't labeled as to 8/16v, and some are labeled wrong 16v for 8v and as 2 door or 4 door.
If I hadn't looked, I would have ordered the wrong one.
Reply
#4
Fixkick,

What paint did you use on that engine in the photo? Sure looks good!
95 Geo Tracker, Build Date 1/95,16v, Fed, Cami, 4x4, MT, Headed for Grenada.
Reply
#5
none, that is shinny aluminum....
i built it up from naked , every inch.
thanks!

that is correct they all mix 8v./16
that is because Suzuki used same vin engine code for both. damn shame that.


GM used U/6 vin codes, and cant use that on Suzuki's they go , huh?
http://www.fixkick.com
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)