01-29-2018, 05:50 PM
Ok just another update. Went out again to give it another try and had some strange results. Got a better hold on the return line and clamped it after 3 seconds key on and the pressure held. I took off the clamp and it continued to hold, only leaking down slightly. It was over 20psi for 1 minute. Remember all the injectors are still unplugged. I would let it bleed down to 10 psi after 2 minutes and then key on again and see if it held. It continued to hold the same 3 more times so I decided to plug in the injectors and see what happens. The first try key on it held for a second and then dropped fast and didn’t hold as well. Second time it barely held then it stopped holding all together. So I pinched the return line and attempted to get the same results I had before with all the injectors unplugged again. It slowly leaked down when I clamped the return line the first time key on but when I keyed on again the pressure dropped to zero instantly. It now continues to drop instantly if the return line is blocked or not. Any thoughts?