02-01-2017, 09:35 AM
(This post was last modified: 02-01-2017, 09:36 AM by jay nesbitt.)
Here it is a year later and ....I bought a 2wd junker for the engine (no good crank had spun brg). Crank might be turned. I swapped stuff for another crankcase and turned crank (.25 mm under). I have fit/ measured the mains and although a little looser than I like, I'm proceeding. I was going to check the thrust clearance, but have not found it either in the FSM or in your data. I must be missing it. Could someone point me in the correct direction?
Thanks!
Jay
Thanks!
Jay