05-11-2016, 12:29 PM
(This post was last modified: 05-11-2016, 12:31 PM by Michtrackerproject.)
ok.. so the fly wheel on this truck is pretty wasted. the holes to bolt to the converter are oblong and the metal is worn thin,, has anyone ever drilled a new set of holes in a the fly wheel to bolt up to. ? it seems that as long as its all centered to the converter it should work,. or maybe I could put some washers on the converter side,, , just not sure of tolerances,, don't want to put pressure on the pump or front shaft./