not sure whats loose there.? the sensor has a clamp bolt, and if tight , nothing is loose save the connector or wires.
the sensor must be removed to find this leak
the lower seal point to the lower pump pan gasket is like 1 inch.
so we are talking a 1 inch place on the whole engine.
but you will find it, if the sensor is removed and put pocket and drive.
im sure
so its a real bog and does it WOT. a steady bog.
so is gas over 6months old?
chevron is good fuel. no lie there;. super good.
the bog can be many things. (ecu inputs tops list) lean fuel mix. (scanning this we see this easy, at B1S1 oxy sensor and long term fuel trim way off. 0.
MAF dirty, needs cleaning.
low fuel pressure, (FPR bad, as most are this old) easy to test with a fuel pressure gauge and pull off vac line see fuel drip there ,?? BAD FPR.
the sensor must be removed to find this leak
the lower seal point to the lower pump pan gasket is like 1 inch.
so we are talking a 1 inch place on the whole engine.
but you will find it, if the sensor is removed and put pocket and drive.
im sure
so its a real bog and does it WOT. a steady bog.
so is gas over 6months old?
chevron is good fuel. no lie there;. super good.
the bog can be many things. (ecu inputs tops list) lean fuel mix. (scanning this we see this easy, at B1S1 oxy sensor and long term fuel trim way off. 0.
MAF dirty, needs cleaning.
low fuel pressure, (FPR bad, as most are this old) easy to test with a fuel pressure gauge and pull off vac line see fuel drip there ,?? BAD FPR.
http://www.fixkick.com