A/T 4speed fails, car wont move until hot.

[zukitrek]

i know nothing, im blind here. (worse than a bat) (id need to be there, to see)
it check the idle switch (0v , each time you got to idle.)
To make sure I get this right, the meaning of this, you mean by idle when rpm needle finally drops to that 800 mark or when it drops somewhere in the RPM instrument?
then see if the DMM can read near center, 7vdc.
If mine don't do the trick. Can you recommend one not from flea bay that perhaps I could get locally? Craftsman etc?
it will if lucky.... (a across the ISC pins, now here else,2 pins, 2 meter leads, across them) probed.
not 0vdc
not 14vdc
if not near 7v, turn the bleed screw until the voltage moves to 7vdc (pay no mind to + and - symbols on LCD screen)
if it moves this voltage good, that means its alive. and working. and meter not fibbing to you.
Cant wait to get home and do it the right way.

some meters will not work here,
crossing fingers your meter works, and no other problems or bad idle switch. etc.

Ok. Will report to you as always.

Gracias Sir Fix!!