09-19-2015, 03:54 AM
(09-12-2015, 10:46 PM)fixkick Wrote: FOGGING OIL.? like used on outboards. ? winterizing....
crank it and spray for 3 seconds. into air cleaner lid off, big port.
real bearings are great beauty, those Nachi are a great example of quality.
cheers!
Thanks, will see about the fogging oil.
I got parts a plenty coming, ready to get busy.
From TrailTough, got a countershaft circlip coming, hope it's the right one. Got a clutch coming from Amazon, hope it's decent enough despite not being as high falutin' as I wanted. Had to go with lesser-than due to having some gift card available on Amazon, took the edge off, allowed me to get a clutch to begin with.
Main worry I have (not sure if necessary) is balance, etc. I marked the original pressure plate's location on the flywheel and the plate…so will put both on a rod and see where they balance, and try to match the new to where the old was (balance wise). Can't afford a spin balance, don't even know where to get that done?
Also have a genuine 093-0598 (8valve) Beck/Arnley cable coming, new rear main seal for engine.
My transfer case mount has some rips in its suspension rubber, not sure I can swing a new one just yet though. The front one for the hanger is cheap ($15 on up), but that round one is $$. (Cheapest I've found is $42 to $70?)
r