Both>?
im not sure what you are doing, the CV axles are bad. tell what is bad first. so i can know job.
none , are special, unless pulling front wheel bearings.
I have never attempted to remove CV axle assemblies, using all 3 ways, only 4c-8 way
1: FSM way, 2 drop axle. , 3 drop inboard side of Arm.
the snap ring is #34 here, is off first.
http://www.fixkick.com/axles/Pan-drop/pandrop.html#cv
and that begs the question, which way? are you doing this
drop ball is FSM way page 4C8
drop whole axle like seen here
http://www.fixkick.com/axles/Pan-drop/pandrop.html
you could drop the Arms from ball side or rear of the A side. dealing with spring tension.
or use the FSM way.
its publish, and free to look.
http://www.acksfaq.com/96-FSM-v1-4c-pdf.htm
read page 4C-8 and ask questions.
snap ring off.
you drop the arm ball end.
then mark parts.
then drop inboard cv flanges.
page 4c-8
http://www.acksfaq.com/96-FSM-v1-4c-pdf.htm
then pull the axle.
type CV in my search box, there.
im not sure what you are doing, the CV axles are bad. tell what is bad first. so i can know job.
none , are special, unless pulling front wheel bearings.
I have never attempted to remove CV axle assemblies, using all 3 ways, only 4c-8 way
1: FSM way, 2 drop axle. , 3 drop inboard side of Arm.
the snap ring is #34 here, is off first.
http://www.fixkick.com/axles/Pan-drop/pandrop.html#cv
and that begs the question, which way? are you doing this
drop ball is FSM way page 4C8
drop whole axle like seen here
http://www.fixkick.com/axles/Pan-drop/pandrop.html
you could drop the Arms from ball side or rear of the A side. dealing with spring tension.
or use the FSM way.
its publish, and free to look.
http://www.acksfaq.com/96-FSM-v1-4c-pdf.htm
read page 4C-8 and ask questions.
snap ring off.
you drop the arm ball end.
then mark parts.
then drop inboard cv flanges.
page 4c-8
http://www.acksfaq.com/96-FSM-v1-4c-pdf.htm
then pull the axle.
type CV in my search box, there.
http://www.fixkick.com