08-15-2014, 08:08 AM
(This post was last modified: 08-15-2014, 08:10 AM by cosmic_splatter.)
Fixkick,
I used your valve procedures. I had them printed off in the shop. TDC on pulley and then did one set. 360 and did other set.
So, you think the new valve cover gasket will seal the gap? I wasn't sure if they were missing a gasket on the distributor/rear cam mount and the rear "hump" was a bit lower as a result.
John
ps. Yes .006. Wrote that from memory. I have the right gap in there.
I used your valve procedures. I had them printed off in the shop. TDC on pulley and then did one set. 360 and did other set.
So, you think the new valve cover gasket will seal the gap? I wasn't sure if they were missing a gasket on the distributor/rear cam mount and the rear "hump" was a bit lower as a result.
John
ps. Yes .006. Wrote that from memory. I have the right gap in there.
95 Geo Tracker, Build Date 1/95,16v, Fed, Cami, 4x4, MT, Headed for Grenada.