i think its a tank protector and is replaced when you get a trailer hitch kit.
ill up that limit, it's default. and small.
any weld shop can fix that bar. easy.
remove it he would
straighten it.
the cut it off
out in new pipe
weld on old cap mount
then try fit, see if it fits, with 2nd pipe end held in place
yes, weld that back on
or just buy a new hitch kit.
might be cheaper. JC whitney?
http://www.rockauto.com/catalog/raframec...ttype=1212
IIRC, had to throw mine away, at doing this.
http://www.rockauto.com/catalog/raframec...ttype=1212
not only that , it is stronger and more tank protection ,.
ill up that limit, it's default. and small.
any weld shop can fix that bar. easy.
remove it he would
straighten it.
the cut it off
out in new pipe
weld on old cap mount
then try fit, see if it fits, with 2nd pipe end held in place
yes, weld that back on
or just buy a new hitch kit.
might be cheaper. JC whitney?
http://www.rockauto.com/catalog/raframec...ttype=1212
IIRC, had to throw mine away, at doing this.
http://www.rockauto.com/catalog/raframec...ttype=1212
not only that , it is stronger and more tank protection ,.
http://www.fixkick.com