Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
96 Tracker axle nut wrench
#11
the beauty of all this , is all parts off the shelf. no $100 tool, you might only use once
thanks so very much for sharing those very clear photos.
and the mil shot, super nice.
CHeers !
http://www.fixkick.com
Reply
#12
You're welcome. So the tool served its purpose last night. But just to give you guys an idea, as strong as the hardened steel pins I put in are, I still manage to break one with the torque wrench at only 120 psi, I then had to keep going because the locking washer wasn't lining up its holes with the locking nut so I was able to do it with only three pins left on the tool but barely, I was able to torque it up to 150 psi. I finally changed the boots on the CV joints. Once the CV axle is out is actually not hard to do.
1996 Geo Tracker, CAMI, 16 valve, 5sp, 4x4, soft top, 2 door, no a/c
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)