10-01-2015, 01:21 PM
(10-01-2015, 07:58 AM)fixkick Wrote: lowes and HDepot, and ACE.
all have this drawer with plugs. rubber and cork, id bet one of the rubbers fit. glued in. even cut down.
yes, there are 2 rear, cluster bearings the old 2 part needle, and not the updated basic ball bearing.
the new part does fit easy.
do you have the real fsm on just trans, i have it.
if you dont have it send me pm, message, with real email and can mail it to you.
Thanks for the offer.
I have the FSM chapters for my kind and the type 2, but not much help at this point other than steps, because main problem is no real press, or special tools. Tried my shaft cooling trick, with hot bearing but no joy this time, had to beat middling countershaft bearing on carefully with rubber mallet and dead blow and wood block combos. I think I have it seated now.
I really wish I had that special tool for the two-fer front and middling-smack in (into the holes cut out for them). Can get one, but another 4 days waiting if I do. Might though since the hurricane rain is likely "helping" with my work.
(5-10") The Lowes plugs were kind of oversized, I should have gotten and cut down, didn't think to. Got some grommets which will fit inside, and can RTV the hole (option 1). Will look elsewhere tomorrow.