Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Esteem 1.6 16valve first start and run
#8
(03-07-2020, 10:27 AM)Jules Wrote: Problems... engine starts when cold but stalls when warms up and won't start again unless I use some starter fluid.
Lean stalls:?
MAF dead, or weak or , air leaks  past the end of MAF on engine size.
but no by below.

Then, it will stall unless I keep the throttle on a little bit.
So it will not hold 800RPM by itself hot.?  is coolant reaching 180F or  more. 195F is top stat markings,
sounds to me like bead IAC/ISC idle speed controls.  what car did this engine come out of , I forgot .. Esteem 1.6l G16B, what year?

I'm getting the following codes:

141 - O2 sensor bank 1 sensor 2 ( useless rear 02 , is only CAT check test only and is its heater element dead, not drawing current failure 1amp is normal)

758 - shift solenoid B electrical... Shift Solenoid ‘‘B’’ (No. 2) Electrical, dead solenoid.  4speed A/T,  no worry until driving it.....


Off hand I'd say ISC if failing, the electric 2 wire ISC valve is stuck, or wire to it bad. cut.
http://www.fixkick.com
Reply


Messages In This Thread
Esteem 1.6 16valve first start and run - by Jules - 12-24-2019, 10:42 AM
RE: Esteem 1.6 16valve first start and run - by fixkick - 03-07-2020, 10:01 PM

Forum Jump:


Users browsing this thread: 3 Guest(s)