Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Can't read CEL
#4
Photo 
Mr fixkick, thank you for answering so thoroughly, I did leave out a lot of info, sorry about that.
This Tracker has the 8v. The sticker under the hood does not say California. 
The DLC connector has 4 pins. I incorrectly referred to the pins with numbers 2 + 3 when I meant B + C.  

I found the NAG switch. I took apart the gauge cluster and removed the NAG switch connector (which had pink and green wires). I tried to read the codes again with the NAG switch removed but still do not see any flashing in any state -- ignition on, cranking, or engine running. I am using a piece of wire. The light is still on, so I assume then we know it's a real code and not a NAG light coming on. What am I missing sir?


Also, there are a few wires going nowhere next to the DLC connector... What is the single wire (orange) pictured far right in the photo I attached? I found The temp gauge sender located under the thermostat was broken off. I replaced it and wired it up but I can't figure out where the heck it is supposed to go.
Reply


Messages In This Thread
Can't read CEL - by eggsalads - 12-19-2019, 01:17 AM
RE: Can't read CEL - by eggsalads - 12-19-2019, 03:14 PM
RE: Can't read CEL - by fixkick - 12-19-2019, 10:53 PM
RE: Can't read CEL - by eggsalads - 12-20-2019, 06:06 AM
RE: Can't read CEL - by fixkick - 12-20-2019, 06:46 AM
RE: Can't read CEL - by eggsalads - 12-20-2019, 07:09 AM
RE: Can't read CEL - by fixkick - 12-20-2019, 09:23 AM
RE: Can't read CEL - by fixkick - 12-20-2019, 09:55 AM
RE: Can't read CEL - by eggsalads - 12-20-2019, 12:06 PM
RE: Can't read CEL - by fixkick - 12-21-2019, 12:04 AM
RE: Can't read CEL - by fixkick - 12-21-2019, 12:09 AM
RE: Can't read CEL - by fixkick - 12-21-2019, 12:31 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)