Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
1996 Geo Tracker Spindle & Hub same as 1998?
#19
the outer bearings are, 2 pieces double tapered roller bearings, that are CRUSH style.
and are pre loaded full time all the time,
123-180ft/lbs

the place you stop (torque wrench) in that range is totally dictated by where the set screws land.
if not run like this, the bearing HAVE NO LIFE SPAN. (even less that 1000 miles)

the chart is here (that max life seen here, is that spec above for preload) Suzuki does not make this rule at all it's TIMKEN rules. applied, (or even KOYO)
The Suzuki engineer had to covert distance, to torque by using the nuts thread pitch angle, to foot/lbs. the bearing actually CRUSHES !
when it does the gap gets to the right magic spot by DESIGN.

http://www.fixkick.com/hubs/life1.JPG

it's not a boat trailer, not in the least. (just did mine yesterday, )
http://www.fixkick.com
Reply


Messages In This Thread
RE: 1996 Geo Tracker Spindle & Hub same as 1998? - by fixkick - 06-17-2017, 05:06 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)