R&R fuel pump 93 4door sidekick

[fixkick]

I'll share a pic of mine I took out to replace the fuel pump.

my pump page has lots of photos.
lots of fail modes too

http://www.fixkick.com/INJECTORS/PUMP/dead-pump.html


i do not have the X/Y measurements project up to tank, but know how to do it easy on car.

mark tank front and right side, with chock.
them with those drill tiny hole (say a #60 drill)
into body, cavity, shell, on side, see that flat surface.
then drill from below aligned with other chock mark.
now inside car chock line hole X to Y... make a cross, bingo, center line of rack top.
if not wanting to drill holes, then you get to project outside to inside, no simple task that.
the right side is easy,
but not front of tank to rear.
and no way to measure from rear with bumper attached.

ive only seen like 3 posts. world wide, doing this of 1000s...
and all were crude and missed the mark, meaning hole was enlarged 2 times. (ugly mess that)
if done carefull
one has a free cover, use weld on side tangs (2 or 4)
with 2 screws or 4. to body. (cargo floor)
and then RTV glue it after remounted.

---

the rack fits down the big hole.
the damaged rack looks like this.