09-12-2015, 06:52 PM
(08-26-2015, 10:00 AM)fixkick Wrote: you'd have to talk to the maker, of that tool.(software/hardware)
the FT3232 is a virtual RST232 USB Uart port. (for serial data transmission and reception)
it transmits on 2 lines , TX and RX .
your car is 1 line i bet., this takes a special driver to make that work. very special. (bidirectional mode) ALDL like.... i bet but for sure dont know, only KIA knows this....
the tool must know who to communicate this ECU at those signalling levels. (0 to 5v? or?) more.?
and the hand shake
then it must know the command sets .
to scan this PCM you need to find a tool maker that supports this exact engine and PCM. a tall order in most cases like this.
you need to find someone that is scanned your same car, that in UK
someone there, a
ok the wiki said
In 1993 a relationship with KIA began, and production of the Kia Pride commenced
i and no idea Kia's made there. wow,...
keep in mind, there are vast numbers of cars made by KIA
just because one ECU communicates to one TOOL, does not mean they all do. not even close...
Hi
Dear fixkick . I find IC MC33290D . This ic Support Bi Directional Mode ( According to you) . do you think this ic is support my Care ?
And i Try to find How to use Handshake on this protocol