Login Register

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
is 8V non-interference>>?????
#2
not good, check the 17mm bolt, many G16s die for one reason, not overheated) Crank snout distruction (loose bolt , will beat the seal to death)
the 8v is not and interference motor.
you can put the #1 and #4 piston at TDC, and spin the cam over and over, . no problems.
not one reported 8v, bent valve, yet. (not counting broken valve springs) or the guy that cracked a cam in half....

good luck to you, it can crank seal or cam. it will be obvious; lid off.
http://www.fixkick.com
Reply


Messages In This Thread
is 8V non-interference>>????? - by barnbiketom - 11-24-2013, 01:55 AM
RE: is 8V non-interference>>????? - by fixkick - 11-24-2013, 03:01 AM
RE: is 8V non-interference>>????? - by fixkick - 11-24-2013, 04:04 AM
RE: is 8V non-interference>>????? - by fixkick - 11-28-2013, 06:03 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)