Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Squish Squish Bish Brakes
#3
(11-04-2021, 04:31 AM)fixkick Wrote:
(11-04-2021, 04:07 AM)Beastcublol Love Scotty Kilmer, were from the same home down, Phoenix Injector sounds like an X Men or Porn name Wrote: Ok (1994Sidekick 4wd, 4 door JLX, 1.6 16V, auto no ABS 229,000 miles). Ive 2 man bled the brakes twice plus tried the Mityvac to remove old fluid (it ended up imploding! but it was like 15 years old) and my brake pedal is still squishy. The vehicle stops well and you can lock the brakes but the pedal is very spongy. I replaced the front pads and rotors and havent driven it much to wear them in but I doubt thats the reason. Any help? ANd what is this thing with the bleeder on it. I read the brake bleed page and did it LR, RF, LF with a helper pumping the brake holding, florr, tighten repeat. Ive done it 1000 times on other cars. TY
no lie it is hard to get  all the air  out the brake lines , cylinders and calipers.
it love to hold bubbles.

one of the best ways  is to do it backwards, pushing fluid from low rear point up hill to the master cylinder, reservoir

that is if the seals in the MC are not bad land leak inside the MC unseen.

motorcycles front are worse, 100% vertical lines flat refuse to bleed top to bottom the bubbles flow up faster than you can pump. the fluid,
same with air craft bottom of landing gear, all up hilll.
omg he is so young the much loved Scotty , RFM reverse flow method.

every word true for sure bubbles want to float high.

https://www.youtube.com/watch?v=L0oUejw5Edc

and always pre prime and fail a dry or new MC.


RFM make sure to keep the  MC reservoir from overflowing on to painted fenders.

bleed on , rock on and be lucky!
Reply


Messages In This Thread
Squish Squish Bish Brakes - by Beastcub - 11-04-2021, 04:07 AM
RE: Squish Squish Bish Brakes - by fixkick - 11-04-2021, 04:31 AM
RE: Squish Squish Bish Brakes - by Beastcub - 11-06-2021, 01:21 AM
RE: Squish Squish Bish Brakes - by fixkick - 11-06-2021, 02:44 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)