09-25-2021, 04:44 AM
https://www.mouser.com/Passive-Component...usZ1yx4avu
29 cents, 0.1uf , 63vdc, may fit read the length spec, IEA code is,
.1 uf is 100nF
or code 104. up to 224 cap codes will work , fit is what matters
and I can not measure you cap length with my calipers
the caps come in 7 different SMD lengths per data sheet there,
what I do is find the max space pad to pad, and get the highest uf that can do the span (space)
hand solders is way way more easy than machine, so it can be as wide as the PC pads allow. no problem
this is in the data sheet and wise
KEMET only recommends wave soldering of EIA 0603, 0805 and 1206 case sizes.
the first one for 0.1 uf size code 805
this 1206 may fit
https://www.mouser.com/ProductDetail/KEM...5PiA%3D%3D
best is using a real caliper measuring tool end to end on SMD burned, in mm is ok
the 1206 3.2mm long fits pad 5.6mm and any larger cap fits 5.6mm pads easy if hand soldered. with flux.
measure you cap,? length.
29 cents, 0.1uf , 63vdc, may fit read the length spec, IEA code is,
.1 uf is 100nF
or code 104. up to 224 cap codes will work , fit is what matters
and I can not measure you cap length with my calipers
the caps come in 7 different SMD lengths per data sheet there,
what I do is find the max space pad to pad, and get the highest uf that can do the span (space)
hand solders is way way more easy than machine, so it can be as wide as the PC pads allow. no problem
this is in the data sheet and wise
KEMET only recommends wave soldering of EIA 0603, 0805 and 1206 case sizes.
the first one for 0.1 uf size code 805
this 1206 may fit
https://www.mouser.com/ProductDetail/KEM...5PiA%3D%3D
best is using a real caliper measuring tool end to end on SMD burned, in mm is ok
the 1206 3.2mm long fits pad 5.6mm and any larger cap fits 5.6mm pads easy if hand soldered. with flux.
measure you cap,? length.
http://www.fixkick.com