02-04-2021, 09:53 PM
Hello newb to the forum though I have been a long time lurker and try to read everything before asking stupid questions. I have looked a about every link I can find and it seems my situation is slightly different than most of what I am finding. I have an off road buggy based off a 89 sidekick (minus body). I understand it is a "narrow" frame and this causes problems fitting the 2.0 but what I don't seem to be finding is where the interference issues are. I am swapping engine and trans/transfer case etc. (2.0 auto trans) This buggy doesn't even have a factory floor pan to be concerned with, but frame rails are intact. We will be fabricating motor and trans mounts as expected but wondering about what other physical issues we will need to be concerned with. Motor arrives Saturday then we will see where it goes. Any input would be appreciated.