'92 sidekick 16v

[danstrayer1]

Ignition failure. Seeking info from anyone on noise suppressor specs or test procedure. I understand that failure of this results in tach failure and ignition failure.
    I would like to know the resistance through that component, and/or the capacitance of the cap inside.  I believe to construct one of these would be very easy, given the specs.  I cannot find these specs ANYWHERE, on line for hours.  Any help greatly appreciated.

that is because suzuki never told that. spec. ever.
what car is this and year, and what engine? 8v or `6valve and G16 engine?

it began in 1991 and ended in 1998.
dtc code 41 or 42, (89/95)  get that after cranking for full 5 seconds? p03xx codes 96 up.?
the signal out of it when dead only kills injection.s
what are the symptoms.?

my spark test page?
https://fixkick.com/no-spark

you lost yours? the suppressor.,?
the resistor is 2k ohms i think,  and me guessing cap is 0.1uF. 200vdc.

spark dead is bad CMP  or ignitor or coil not this, suppressor.

so little facts told  i am at a told loss, (yoda says, the force will tell me soon)

code 42 is cmp is dead.


code 41 means  the igniter is dead. (or suppressor is missing)  41 means it can not see coil primary sgnales even if spark is good.  and tachmeter dead too and even
the cruise control if opted here can short and wreck this signal.  (unplug cruise box in dash)


The Supressor, creates the TACHO signal and the ECU watches this and if missing cut fueling DEAD so as not to case flooding or worse a huge fire with wild driver at the key, cranking endlessly.
   1992 16v.....sorry, I left that out accidentally.  I did measure the suppressor I have, through 2 of the 4 wires, there is about 2100 ohm, so I think that is good. 2 other  wires  indicate operational capacitors in the unit. The car runs fine for months at a time, then abruptly dies, sometimes restarts but now has a hard fail.  Tachometer plummets to zero instantly upon failure, which is what put me onto this suppressor track.  Hall effect unit inside distributor is ordered, ign coil resistance is OK, around 1.5 ohm on the primary side.
   Thank you for responding.