Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
On the ground transmission flush...
#2
take out the side plug (filler /level check)
put in 1qt of oil base paint thinner, even seen at walmart in paint department.
the spin the box with large drill motor.
in gear. get the cluster gear going fast this way, in 4th gear from rear or 4th front.
try 1,2,3,4 gears,
then drain it.
that is the only way I know to do this, and not using something that will wreck steals like Lucas oil junk.

the tip of the tranny fits a 1/2" drill chuck , i put 2 turns of duct tape on end from pilot shaft and spun it good.
good luck !
even by hand is better than nothing.

or alt way is use GL4 , drive 10 miles, lots of shifting.
drain and fill now.
http://www.fixkick.com
Reply


Messages In This Thread
RE: On the ground transmission flush... - by fixkick - 06-06-2018, 05:58 AM

Forum Jump:


Users browsing this thread: 4 Guest(s)