Its me again. Starting to warm up over here so i decided to take a break from engine and work on this bad trans leak. 95 auto 4x4 2dr 16v. Does anyone have pics of the 3speed auto? Ive replaced the pan gasket 5 times now. I replaced the shift shaft seal and the tcc connector O ring thats on the driver side on top of the pan. Im loosing my mind. Is there something on the very top of the trans between body/floor and trans that has an O ring? The entire pan gasket is wet all the way around with the mass dripping from the rear of the trans. Im starting to suspect... is there a seal between the trans and T case? How hard to remove T case?
Im convinced its not a pan gasket or warped pan. Ive gone over and beyond to rule that out. Ive used a feeler gauge between pan and trans with no gasket.. no gaps found. I used sealer on both sides of the rubber pan gasket one time. Tourque was correct and in order. Ive tried also under torquing and over torquing. Always same results. It cant be the pan/gasket. Ive used new gaskets every time.
Im convinced its not a pan gasket or warped pan. Ive gone over and beyond to rule that out. Ive used a feeler gauge between pan and trans with no gasket.. no gaps found. I used sealer on both sides of the rubber pan gasket one time. Tourque was correct and in order. Ive tried also under torquing and over torquing. Always same results. It cant be the pan/gasket. Ive used new gaskets every time.