1996 1.6 16V IGBT Specs?

[fixkick]

cool
get a spark map? from a 1995 toyota 1.6L corolla, 40million made!, vast. surely one of those is to be found.?
cold idle is not controlled until 150f temp is hit, the IAC therm device does that seen mounted below TB. (id bet they just keep the ISC closed or nearly until 150 hits)
The spark advance table is complex and 3d;
RPM and load.(and hot cold engine and even cranking rules) yes complex it is. unlike say the old 89 with vacuum+centrifugal system. (even in Acceleration mode, different)
One of the reasons the engine can get near 30mpg is that. (perfect advance under all conditions, it's really cylinder pressure that matters most, and rpm)
getting that pressure to max out at the sweet spot just after TDC happens (rod angle), (the leading of the spark sets that point) (and Rod to crank pin angle is the key there (a lever it is)

I starting map should be easy (not cranking that is at 0 advance of base) the starting of making a map. there are computer models that can do that easy.
it asks for displacement 1.6L
and VE (volumetric efficiency (head type 16v very high) (the CAT will lower this at high RPM if present )
AND MODE, flat cruise or hills and acceleration modes. (3 rules there)
many universities. have mechanical engineering dept for engines (MIT), and have this on their web sites. combustion engineering.
it's a lot of fun to run those modeling programs . and not hard to do, (users)

that is my spark of ideas to you...