12-01-2013, 08:28 AM
(This post was last modified: 12-01-2013, 08:30 AM by barnbiketom.)
OK no codes.. cept 12...12..12...
With no freeze.the timing IS MOVING around slightly..maybe 2-3 degrees...
With freeze jumped it IS STILL. Except it does advance when I rev it.. I am thinking it is OK...
Also set the tps earlier to correct spec and switch is under 300 ohm at idle
BUT tonite i notices the idle air bypass screw under the rubber plug on TB IS ALL THE WAY IN.. IF I UNSCREW IT..IDLE GOES UP. I SCREWED IT BAC IN
Sound good????
Maybe I just drive it
With no freeze.the timing IS MOVING around slightly..maybe 2-3 degrees...
With freeze jumped it IS STILL. Except it does advance when I rev it.. I am thinking it is OK...
Also set the tps earlier to correct spec and switch is under 300 ohm at idle
BUT tonite i notices the idle air bypass screw under the rubber plug on TB IS ALL THE WAY IN.. IF I UNSCREW IT..IDLE GOES UP. I SCREWED IT BAC IN
Sound good????
Maybe I just drive it