11-30-2013, 10:55 PM
(This post was last modified: 12-01-2013, 06:56 AM by barnbiketom.)
91 1.6
When I jump the connector the timing isn't "jumping all over" but if I rev it up it still advances..is that wrong.
Seems like no difference jumped or not. Mark stays same when jumped
No codes..unless one there in the hour before I tried to time it. CEL proves out. Then always off when running...
It starts and runs nice but just need to confirm base timing and my lower balancer is off ( slipped) by 4 degrees..so need to get timing sorted out.
When I jump the connector the timing isn't "jumping all over" but if I rev it up it still advances..is that wrong.
Seems like no difference jumped or not. Mark stays same when jumped
No codes..unless one there in the hour before I tried to time it. CEL proves out. Then always off when running...
It starts and runs nice but just need to confirm base timing and my lower balancer is off ( slipped) by 4 degrees..so need to get timing sorted out.