02-07-2018, 09:21 PM
new car to the barn questions, sure. ( car never driven new, so no basis to compare power then to now)
but in fact if power was too low
it will get worse ,
i got lost at GPL ,sorry,
the car is not stock. so any answers come hard, for that fact.
cel .
key on, the CEL must glow, if lamp burned out. or someone removed it to hide failures (code 51 tops list) to sell it. or put black tape on lamp same reasons. the ECU drives the lamp directly.
the insert the jumper (now) DIAG.. use the correct pins, note wire colors there. per my page,
the lamp flashes 12s. = good
start engine, still flashes 12s
drive say 20 miles its flashing 12s all the time.
all G16a here do that until 1996 (OBD2) when the flash codes ended and the cheap over the counter scan tools started to work. OBD2.
id bet lamp missing, 1/2 have are here. #18-GE bulb (usa lamp code)
but in fact if power was too low
it will get worse ,
i got lost at GPL ,sorry,
the car is not stock. so any answers come hard, for that fact.
cel .
key on, the CEL must glow, if lamp burned out. or someone removed it to hide failures (code 51 tops list) to sell it. or put black tape on lamp same reasons. the ECU drives the lamp directly.
the insert the jumper (now) DIAG.. use the correct pins, note wire colors there. per my page,
the lamp flashes 12s. = good
start engine, still flashes 12s
drive say 20 miles its flashing 12s all the time.
all G16a here do that until 1996 (OBD2) when the flash codes ended and the cheap over the counter scan tools started to work. OBD2.
id bet lamp missing, 1/2 have are here. #18-GE bulb (usa lamp code)
http://www.fixkick.com