11-13-2013, 05:04 AM
the alarm module , must have power,
the time out is the seat belt time out. it many time out for HL too, I never tried that, i just slam off the fast.
the module may be a tad dumb, if you have more than one input wrong.? 1 beeper it has, and 5 faults , i must admit ive never tired every permutation of fault. 25 possible?
check all pins to it, i bet one or more pins are in the wrong state (voltage)
page 12 ,in this PDF, (whole car there) is the alarm module.
http://www.fixkick.com/CEL/DLC/DiagJump.html
normal key on. is?
pin 1- 0v setbelt secure.
pin2- 0v (park lamps off) and HL too.
pin3- out to lamp seat alarm
pin4- 12v for key inserted? (not sure)
pin5- 12v power
pin 6- 0v door switch. grounds with door open , 0v closed.
pin 7- 0v. ground
make sure all voltages are correct before wondering if the alarm acts odd. i forget logic on pin 4 sorry.
the time out is the seat belt time out. it many time out for HL too, I never tried that, i just slam off the fast.
the module may be a tad dumb, if you have more than one input wrong.? 1 beeper it has, and 5 faults , i must admit ive never tired every permutation of fault. 25 possible?
check all pins to it, i bet one or more pins are in the wrong state (voltage)
page 12 ,in this PDF, (whole car there) is the alarm module.
http://www.fixkick.com/CEL/DLC/DiagJump.html
normal key on. is?
pin 1- 0v setbelt secure.
pin2- 0v (park lamps off) and HL too.
pin3- out to lamp seat alarm
pin4- 12v for key inserted? (not sure)
pin5- 12v power
pin 6- 0v door switch. grounds with door open , 0v closed.
pin 7- 0v. ground
make sure all voltages are correct before wondering if the alarm acts odd. i forget logic on pin 4 sorry.
http://www.fixkick.com