08-11-2017, 10:09 AM
If that's all you need to do, then I think it's not that bad.
Angle grinder, cut off wheels, a stout wire wheel, appropriate gauge
sheet metal, and Chinese stick welder. Maybe Oxy Acetylene with rosebud tip
to help fabricate a good fit. A have a bit of that rust too, and
I am also considering using fiberglass as an alternative.
Angle grinder, cut off wheels, a stout wire wheel, appropriate gauge
sheet metal, and Chinese stick welder. Maybe Oxy Acetylene with rosebud tip
to help fabricate a good fit. A have a bit of that rust too, and
I am also considering using fiberglass as an alternative.