07-24-2017, 10:19 AM
Okay, removed belt and turned cam, but rotor only points in one direction with E at top. That direction is about 4 o'clock looking at the face of the rotor, which is where I have #1 wire. I took pictures but they are not displayed when I attach them from my computer. I labeled the old cap before removing the wires so "think" I have them correct on the new cap. I tried moving them all 180 and they don't fit the cap well that way.
Should have left everything alone except change the timing belt and start it, before replacing cap, rotor, plugs, etc.
Picture, if I could post also shows what appears to be a good key locating cam gear. Again, engine ran fine before starting this 60,000 miile maintenance project.
Phil
Should have left everything alone except change the timing belt and start it, before replacing cap, rotor, plugs, etc.
Picture, if I could post also shows what appears to be a good key locating cam gear. Again, engine ran fine before starting this 60,000 miile maintenance project.
Phil