06-09-2017, 02:48 AM
As far as I know, there is no access panel. I was thinking to add one. You should be able to see from underneath where the pump mounts
in relation to the rear deck. You can then measure, or maybe just count the stamped stiffening ribs. Then I might drill a small hole from
inside to check accuracy with respect to the center point of the fuel pump. I would then fab something up to get good seal for the
access panel and keep the stiffness of the deck panel. The bigger concern is it is likely that you need to remove the tank anyhow
because the tank mounts are rusting away. There's a guy in Canada that makes them for like $150.00.
in relation to the rear deck. You can then measure, or maybe just count the stamped stiffening ribs. Then I might drill a small hole from
inside to check accuracy with respect to the center point of the fuel pump. I would then fab something up to get good seal for the
access panel and keep the stiffness of the deck panel. The bigger concern is it is likely that you need to remove the tank anyhow
because the tank mounts are rusting away. There's a guy in Canada that makes them for like $150.00.