10-25-2013, 12:29 AM
cute seller, but very common.
to be truthful , im surprised any 22 year old car has belt warnings working.> LOL !
http://www.fixkick.com/look/91-complete.pdf
the logic for this is inside the unit called the WAC , your wac is out of WACK. lOL 2.
the full schematic is here, see page.12 here PDF page 12, warning alarm controller.
7 wires, but 2 are power. it beeps when unhappy.
pin 1 is is seat belt. and when you CLICK IT, the switch grounds pin 1. and the buzzing stops and the lamp goes out.
pin 2 is head light monitor, if you turn off engine and exit car, the buzzer , makes noise. Lights left on. in fact its parking lights left on, or both .
pin 3 is seat belt output for the lamp. (im not sure all conditions its glows, i never paid attention to it, cept for belts)
pin 4 is key is inserted logic input. (buzzes with exit from car , key left in car)
pin 5 is ign 12v.
pin 6 is left door switch ( you exited car,)
pin 7 is ground.
if the seat lamp goes on , the belt switch is bad, if buckled up. or bad switch ground wire. conn.
im not sure why the HL effects belts at all, unless pin 5 is open? cut ,fell off?
to be truthful , im surprised any 22 year old car has belt warnings working.> LOL !
http://www.fixkick.com/look/91-complete.pdf
the logic for this is inside the unit called the WAC , your wac is out of WACK. lOL 2.
the full schematic is here, see page.12 here PDF page 12, warning alarm controller.
7 wires, but 2 are power. it beeps when unhappy.
pin 1 is is seat belt. and when you CLICK IT, the switch grounds pin 1. and the buzzing stops and the lamp goes out.
pin 2 is head light monitor, if you turn off engine and exit car, the buzzer , makes noise. Lights left on. in fact its parking lights left on, or both .
pin 3 is seat belt output for the lamp. (im not sure all conditions its glows, i never paid attention to it, cept for belts)
pin 4 is key is inserted logic input. (buzzes with exit from car , key left in car)
pin 5 is ign 12v.
pin 6 is left door switch ( you exited car,)
pin 7 is ground.
if the seat lamp goes on , the belt switch is bad, if buckled up. or bad switch ground wire. conn.
im not sure why the HL effects belts at all, unless pin 5 is open? cut ,fell off?
http://www.fixkick.com