transfer case needle output needle bearing removal

[fixkick]

i just uploaded it.
with this comment.
Description: as you can see , you wont have this set of tools
so I pull the seal first. (after all its best not to reuse seals, using a pro grade seal puller, so as not to damage the bore)
then find some PIPe, that fits in the bore;
iron pipe, EMT, PCV, elect. plastic EPT, (any pipe you can find, best is to collect them , a life time project keep all scrap pipe, for jobs like THIS)
and make it fit the bore, some why . (mill it, or in lathe or any why to make it fit loose fit.)
the using rubber mallet drive it out.
or if that fails your press.
press it out. using a shop hydr. press.
what not to do, is use a screw driver and a steel hammer,.

keep in mind , you will need some pipe to put the new one back or the undamaged old one.
or other shims, washers, and the like.
or take it to a shop and have a machine shop pull it.
they know what to do .