Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Crankshaft Cog good, but not tight - replace?
#14
What is idle at cold startup? Seems to want to be 1500 plus ... ouch.

Got Check Engine again after I forgot to plug TPS back in after adjustment ... that was funny.

Not sure if I needed 0.026" feeler gauge in there while adjusted .. didn't like result anyway.

Ebrake cable definitely cause of dragging brake - can't even pull old cable through sheath! ... replaced and adjusted ... will do other later ... shop so small I can only do stuff on one side!

Found rear differential breather tube was broken .. hope not too much grit got in there!

Blower fan definitely a connection .. at all speeds, a big THUMP on the housing made it work. Suspect brushes? or simple connection. Damn thing stays working once it's working ... I hate that.
Reply


Messages In This Thread
RE: Crankshaft Cog good, but not tight - replace? - by Mizamook - 11-09-2016, 02:03 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)