Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Crankshaft Cog good, but not tight - replace?
#10
great job, super.
12 is good, means no errors.
the TPS is a bit of pain, on all 16v , the stop point is blocked by metal mount brackers.
if the hand is steady , one feeler gauge will do the trick here.
the 16v has no dasy pot so no need to retract it , its not there on any 16v engine with the side draft Throttle body.
http://www.fixkick.com
Reply


Messages In This Thread
RE: Crankshaft Cog good, but not tight - replace? - by fixkick - 11-08-2016, 11:01 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)