Login Register

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
CV boot
#2
there are many makers of split boots, some work , some do not. some are a just generic boots. they usually don't fit. or leak.

here is my pan pull page (actually a contributors) and shows the inner and outer boots well.
http://www.fixkick.com/axles/Pan-drop/pandrop.html
as you note, there are 3 ways , 1, the above.
2 split boot tricks.
3: pull the side down from the axle end. FSM 96' chapter 4C covers this. here is the full chapter in PDF.
http://www.acksfaq.com/96-FSM-v1-4c-pdf.htm
right side is on page. 4C7 , "right driver shaft remove and disconnect...."
if there is a short cut to this, im not sure, see here.
http://bbs.zuwharrie.com/content/topic,1...msg1156298

and , off car
http://www.acksfaq.com/cvhalfshaft.htm

good luck to you, more on the maf , tests. later today. cheers !
http://www.fixkick.com
Reply


Messages In This Thread
CV boot - by gorkyb - 04-26-2013, 03:58 AM
RE: CV boot - by fixkick - 04-26-2013, 10:31 PM
RE: CV boot - by gorkyb - 04-28-2013, 11:24 AM
RE: CV boot - by fixkick - 04-28-2013, 11:01 PM
RE: CV boot - by gorkyb - 04-28-2013, 11:54 PM
RE: CV boot - by fixkick - 04-29-2013, 02:32 AM
RE: CV boot - by gorkyb - 05-01-2013, 10:25 AM
RE: CV boot - by fixkick - 05-01-2013, 11:02 AM
RE: CV boot - by gorkyb - 05-01-2013, 11:14 AM
RE: CV boot - by fixkick - 05-01-2013, 11:42 AM
RE: CV boot - by gorkyb - 05-05-2013, 06:33 AM
RE: CV boot - by fixkick - 05-05-2013, 07:35 AM
RE: CV boot - by gorkyb - 05-05-2013, 07:49 AM
RE: CV boot - by fixkick - 05-06-2013, 12:57 AM
RE: CV boot - by gorkyb - 05-29-2014, 01:56 AM
RE: CV boot - by fixkick - 05-29-2014, 02:47 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)