03-21-2016, 12:42 AM
fixkick, Thanks for the information, is explains a lot about the amount of system oil needed. Going by the FSM it states 10ml difference between what the compressor holds and full system volume. It appears that more is needed since the FSM said to add 10ml for the receiver/drier replacement. My compressor is a Sanden model SD7B10 and on a spec page by them it listed pag 46 oil as correct expect in the SD7B10 with a keyed shaft and it lists Pag 100 as the correct one.
I am going to pull the parts tomorrow and drain the original compressor to see just how much oil is in it. I probably should have done that first for a reference/starting point. I will take that oil to an a/c shop and find out what viscosity it is.
Thanks again,
TM96
I am going to pull the parts tomorrow and drain the original compressor to see just how much oil is in it. I probably should have done that first for a reference/starting point. I will take that oil to an a/c shop and find out what viscosity it is.
Thanks again,
TM96
1996 Tracker 16V 5sp 4x4 2 door