Engine Harness Connections??

[fixkick]

hello
insert the DLC diagnostic jumper, (paper clip work) DLC is next to main battery,
and crank , 5seconds max. release key, not off.
and will tell you why its not making spark !
code 42 or code 41
it will
42 is dead CMP cam sender
41, means the ignitor dead, or dead coil primary

im sure i have now spark page
http://www.fixkick.com/IGN_timing/no-spa...CK_:_89-95

cheers

So I tested for spark again and I'm not getting spark at all on any cylinder or from the ignition coil to distributor. The ignition coil is new and I tested for resistance and it meets the specs for primary and secondary. I tested the voltage on the plug to the ignition coil and it has power (meets what's required but can't remember the exact reading). I'm not sure what else could be causing a no spark. I looked over your page for cranks but won't start but there's a lot of information on there and I'm on a bit on a time limit now.
I don't have a jumper to connect to hook up and I've called every auto store near me and no one has one (what is this?)
. So if there's a way to make one at home walk me through it if it's necessary to see what's going on now. As always, I appreciate all the help.

what jump is that.?

not sure what you want to make, sorry

good evening...

---

the 2 fuses are IG-coil and FI
both must be good. or no spark ,nor fuel.
CEL lamp must glow key on. or ECU is dead. or fuse. bad.
then spark
if no spark diag mode is the truth.

94-tbi