09-12-2013, 12:55 PM
(09-12-2013, 12:08 PM)fixkick Wrote: ouch a bearing and that passenger side CV, is a pain.
that is real smart working on the spare.
yes, i moved that content to the new page. today.
easier to find now.
those bearings are not cheap. $50 a set...
I think your ready to roll..
good luck to you and your car.
thanks, i'm working on replacing next to everything. whole front end will be new here before long(just balljoints/tie rod ends after this), going to try to get everything all put together before winter comes around. struts/shocks up next. i'm looking forward to the bolts on the rear....(have a friend with an oxy/acetylene torch however)
yeah, national bearings, $55 i think is what i paid?? replaced the drivers side some months ago, but it was making a little noise.
oh yeah, neat trick to getting ball joints to pop out of a spindle. get a jack under the a-arm and lift it, then just hit the spindle with a good sized hammer right where the ball joint goes through, and it pops right out.