if on the web, there are 2 ways to make a book
1;click print
2: our use web to PDf, now its a pdf book, next take pdf to real copy center (lots) tell them to print it, last one i did was $50 . and 2inches thick (for a friend,)
if not doing front back, page, 4" thick
my jeep, fsm is 7000 paged, from jeep, not printable , ever, but could do s chapter, or all 200 schematics there
after all that the ebay books look cheap, and way less work
i never do this,why?
if say HVAC is sick
id print out the Hvac chapter,
or if setting valve lash, id print just that out, then trash it later
on new cars the information is hUGE.
, edited
my vision is no good at night, early cataracts...
lots of sources all linked here
http://www.fixkick.com/index9.html
1;click print
2: our use web to PDf, now its a pdf book, next take pdf to real copy center (lots) tell them to print it, last one i did was $50 . and 2inches thick (for a friend,)
if not doing front back, page, 4" thick
my jeep, fsm is 7000 paged, from jeep, not printable , ever, but could do s chapter, or all 200 schematics there
after all that the ebay books look cheap, and way less work
i never do this,why?
if say HVAC is sick
id print out the Hvac chapter,
or if setting valve lash, id print just that out, then trash it later
on new cars the information is hUGE.
, edited
my vision is no good at night, early cataracts...
lots of sources all linked here
http://www.fixkick.com/index9.html
http://www.fixkick.com