12-09-2015, 03:07 PM
Perfect. I suspected it still wasn't 100% right.
Just so I understand. Reading your ECM connector chart it shows crank signal as A2 and it appears it's a system voltage input. Does that mean I can just feed it off the same 12v that I feed to the starter solenoid? I just want to make sure I'm reading the language the right way so I don't fry the ECM.
Code 24 means I have hp left on the table then? I'll head down and pick up a VSS out of a sidekick. There appears to be a few write ups on this. I'll get that taken care of.
Thanks again
Just so I understand. Reading your ECM connector chart it shows crank signal as A2 and it appears it's a system voltage input. Does that mean I can just feed it off the same 12v that I feed to the starter solenoid? I just want to make sure I'm reading the language the right way so I don't fry the ECM.
Code 24 means I have hp left on the table then? I'll head down and pick up a VSS out of a sidekick. There appears to be a few write ups on this. I'll get that taken care of.
Thanks again