12-01-2015, 10:28 AM
it should calibrate ok,
you want the switch to open just as your right foot twitches down, if not and it delays switching open it fights you, and is dangerous having a delay like that.
it bucks a bit. Human fighting the idle servo.
no, on crank cog but the front marks on cover and pulley will be ok, most times. 99% (1% is defective pulley)
sure belt looks good, no cracks , not shredding, and not loose.
crank cog 17mm bolt at 94ft lbs... never loose..... or at old spec. (ore 95 spec is wrong)
good luck to you !!!!!!!!!!!!!
you want the switch to open just as your right foot twitches down, if not and it delays switching open it fights you, and is dangerous having a delay like that.
it bucks a bit. Human fighting the idle servo.
no, on crank cog but the front marks on cover and pulley will be ok, most times. 99% (1% is defective pulley)
sure belt looks good, no cracks , not shredding, and not loose.
crank cog 17mm bolt at 94ft lbs... never loose..... or at old spec. (ore 95 spec is wrong)
good luck to you !!!!!!!!!!!!!
http://www.fixkick.com