95, obd1 installed in rear engine tube buggy...
no vss
no cel wired (currently)
16v>3sp>doubler>tcase
e2000 knock off pump inline
motor was sat for 4-5 years; was a good j/y pull.
....trying to get this buggy going; started right up, and was running fine in shop every time I started it for a week (no load)
went to get it out, and bog, stall, wet black plugs.
And now no start...???
rechecked valve timing, distributor timing, good keyway, has spark, getting fuel.
assume lash is ok as it was running good.
egr clean, not stuck open, modulator good too...
Thinking ecm; have one coming to test...swapped MAF 'causeI had a spare...
also thinking pump is 'overpowering' regulator; was running rich, and wet black plugs....will check psi tonight--is this possible?
what all else can I check while waiting for ECU?
VERY frustrating; was building this for months, and went to drive out of shop and fell flat....
ASIDE- hope retirement's been good to you Jerry; been a few years since I've had to bug you!
no vss
no cel wired (currently)
16v>3sp>doubler>tcase
e2000 knock off pump inline
motor was sat for 4-5 years; was a good j/y pull.
....trying to get this buggy going; started right up, and was running fine in shop every time I started it for a week (no load)
went to get it out, and bog, stall, wet black plugs.
And now no start...???
rechecked valve timing, distributor timing, good keyway, has spark, getting fuel.
assume lash is ok as it was running good.
egr clean, not stuck open, modulator good too...
Thinking ecm; have one coming to test...swapped MAF 'causeI had a spare...
also thinking pump is 'overpowering' regulator; was running rich, and wet black plugs....will check psi tonight--is this possible?
what all else can I check while waiting for ECU?
VERY frustrating; was building this for months, and went to drive out of shop and fell flat....
ASIDE- hope retirement's been good to you Jerry; been a few years since I've had to bug you!