10-12-2015, 09:54 AM
I am about ready to seal up the spacer case, with the end cap and output shaft seal.
The dry area outside those has no drain slot or weep hole that I can tell. So how would one know if the seals end up leaking or not in that area?
OK to drill a 1/16" weep hole at bottom perchance? Not counting on doom but just wondering how to know if any leak arising is from there? So I know to fill it up full of ATP AT-205 seal polymer goodness (planning ahead)?
The dry area outside those has no drain slot or weep hole that I can tell. So how would one know if the seals end up leaking or not in that area?
OK to drill a 1/16" weep hole at bottom perchance? Not counting on doom but just wondering how to know if any leak arising is from there? So I know to fill it up full of ATP AT-205 seal polymer goodness (planning ahead)?