10-05-2015, 09:42 PM
(This post was last modified: 10-05-2015, 10:13 PM by greenfield54.)
The sensors I used are brand new with the same part nos. as the originals. Now I understand how very important shielding and good connections are important particularly with CKP. Now this is what I will do.
1.Pull plugs of all injectors.
2.Remove spark plugs to lessen load on starter and battery.
3.Monitor signals from CMP/CKP.
4.Monitor trigger signals to S102976 ICs.
Question. What pins of the ic should I monitor? I cannot find data sheets or at least pin identification of the ic.
At the moment I cannot find the ICs here so I asked for quotation from Alibaba.com. Problem is the minimum order is 10 pcs. I am thinking that I can use the others on points type distributors which are still in use down here. I will drive the IC with the points and the IC fires the coil. Do you think this is possible? Hope you can provide a simple diagram.
Thanks again. Though my knowledgeon these things are not of the same high quality as yours, I am learning a lot.
1.Pull plugs of all injectors.
2.Remove spark plugs to lessen load on starter and battery.
3.Monitor signals from CMP/CKP.
4.Monitor trigger signals to S102976 ICs.
Question. What pins of the ic should I monitor? I cannot find data sheets or at least pin identification of the ic.
At the moment I cannot find the ICs here so I asked for quotation from Alibaba.com. Problem is the minimum order is 10 pcs. I am thinking that I can use the others on points type distributors which are still in use down here. I will drive the IC with the points and the IC fires the coil. Do you think this is possible? Hope you can provide a simple diagram.
Thanks again. Though my knowledgeon these things are not of the same high quality as yours, I am learning a lot.