09-23-2015, 06:24 AM
no pre dry,
but the tube of 1211 covers this as does the FSM for 1996.
tube only says, tack free 30m and cured 100% in 24hrs.
page 30, 5sp fsm
"After cleaning mating surfaces of both cases, coat mating
surface of upper case (8) with sealant evenly and put it over
lower case (6).
Place bolts at their positions and check to make sure that
their height from case surface is the same before tightening
them. Also, check clamp position and torque them to specification.
Tightening torque
Upper case bolt (a) : 23 N·m (2.3 kg-m, 17.0 lb-ft)"
no delay , stated on any page in the official tranny book.
why take fly off? is it needing a shave?
good luck! I think it's a go...
but the tube of 1211 covers this as does the FSM for 1996.
tube only says, tack free 30m and cured 100% in 24hrs.
page 30, 5sp fsm
"After cleaning mating surfaces of both cases, coat mating
surface of upper case (8) with sealant evenly and put it over
lower case (6).
Place bolts at their positions and check to make sure that
their height from case surface is the same before tightening
them. Also, check clamp position and torque them to specification.
Tightening torque
Upper case bolt (a) : 23 N·m (2.3 kg-m, 17.0 lb-ft)"
no delay , stated on any page in the official tranny book.
why take fly off? is it needing a shave?
good luck! I think it's a go...
http://www.fixkick.com